Sonnenkraft - POWER modules ALPIN

Description

POWER modules ALPIN for high snow loads

— Suitable for areas with very high snow loads
— Stronger module frame with more flexibility
— Better stiffening of the module through the installation of optional backrails on the back of the module

Snow loads up to 8,000 Pa
Tested with rafter anchors and backrails in accordance with SPF test specifications In order to stiffen the POWER-MODUL ALPIN 325 Wp depending on the installation situation and withstand the highest loads of up to 8,000 Pa, two optional backrails are are attached to the rear of the module. Through an inhomogeneous SPF snow load test, the module was tested for downslope forces and meets the highest standards of quality and safety.

• 325 Wp ALPIN black with 60 full cells
  Design: black frame and black back sheet rear foil (front: black, rear: white)
• 425 Wp HC ALPIN black (2 x 2 mm) with 108 bifacial half-cut
  Design: black frame and transparent encapsulation encapsulation foil and black screen print
• 400 Wp HC ALPIN terracotta (2 x 2 mm) with 108 half-cut
  Design: red frame and red encapsulating film especially for monument conservation

Datasheet:

Datenblatt-fuer-hohe-Schneelasten-POWER-ALPIN_325_430
Datenblatt-fuer-Denkmalgeschuetzte-Gebaeude-TERRACOTTA_400